(<Back)

HP Laserjet 2100/ 2200 Paper Feed
Repair Kit Instructions

Remove tray 1 pickup roller:

Step 1:
Remove the following assemblies:
• Remove the toner cartridge.
• If installed, remove tray 3.
• Remove the cassette from tray 2.
• Remove the DIMM cover.
• Remove the rear cover.
• Remove the top cover.
• Remove the left cover.
• Remove tray 1.

Step 2:
Rotate the left idler roller (on the cooling fan side) until its release tab is exposed

Locate left idler roller release tab (above)

Step 3 :
Press and hold down the separation pad.

Step 4:
Grasp the roller, as shown below. Press and hold the release tab.

Step 5:
Slide the idler roller to the left (toward the fan side).

Step 6:
Repeat steps 2 through 5 for the right roller with all actions oriented toward the printer
drive-assembly side.

Release roller (above)

Step 7:
Press and hold the roller release tab that was exposed when the right roller was moved.

Step 8:
Move the roller slightly to the right (toward the printer drive assembly), and rotate it
forward and out.

Release tray 1 separation roller (above)

Remove tray 1 separation pad assembly:

Step 1:
Remove the following assemblies:
• Remove the toner cartridge.
• If installed, remove tray 3.
• Remove the cassette from tray 2.
• Remove the DIMM cover.
• Remove the rear cover.
• Remove the top cover.
• Remove the left cover.
• Remove tray 1.
• Remove the tray 1 pickup roller assembly.

Step 2:
Rotate the separation pad fully forward.

Step 3:
Gently squeeze the mounting feet of the assembly to release it from the pivot pins.

Step 4:
Lift off the tray 1 separation-pad assembly.

Step 5:
If required, remove the single separation-pad mounting bracket mounting screw and
remove the mounting bracket.

Remove tray 1 separation-pad assembly (above)

Replace tray 2 pickup roller:

Step 1:
Remove the two rollers from the pickup roller (below)

Remove rollers

Step 2:
Place the two rollers on the ends of the replacement pickup roller

Replace rollers (above)

(<Back)