(<back)

HP Laserjet 2300 Maintenance Kit Installation

Tray 1 pickup roller

Step 1:

Remove the following covers
• I/O cover
• DIMM cover
• rear cover
• front cover

Step 2:

Use a flatblade screwdriver to release the tab on the cam at the right side of the pickup roller.

Step 3:

Slide the cam and the white, plastic roller toward the right side of the printer to release the
pickup roller.

Removing the tray 1 pickup roller (diag above 1 of 2)

Step 4:

Rotate the pickup roller and lift it off of the pickup roller shaft.

Removing the tray 1 pickup roller (above diag 2 of 2)

Tray 1 separation pad

Step 1:
Remove the following covers and assemblies
• all covers and the control-panel assembly
• tray 1 assembly

Step 2:
Remove one screw from the tray 1 separation-pad assembly.

Removing the tray 1 separation pad (above diag)

Tray 2 pickup roller

Step 1:
Remove tray 2 and place the printer so that it rests on its rear cover.

Step 2:
Use a flatblade screwdriver to release the tab on the white, plastic lever at the left
side of the tray 2 pickup roller, and then rotate the lever to a position perpendicular to its
original position.

Removing the tray 2 pickup roller (diag above 1 of 3)

Step 3:
Slide the lever toward the left side of the printer and through the hole to remove it.

Step 4:
Slide the pickup roller toward the left side of the printer.

Removing the tray 2 pickup roller (diag above 2 of 3)

Step 5:
Use a flatblade screwdriver to release the tab on the lever at the right side of the
pickup roller

Step 6:
Rotate the lever and slide it toward the right side of the printer in the same manner as the
lever on the left side. Sliding the right-side lever releases the pickup roller shaft.


Removing the tray 2 pickup roller (diag above 3 of 3)

Step 7:
Lift the pickup roller out of the printer.

Tray 2 and 250-sheet feeder separation pad

Step 1:
Slide tray 2 or the media tray of a 250-sheet feeder out of the printer.

Step 2:
Press down the lift plate to lock it in place.

Step 3:
Use a flatblade screwdriver to press two tabs (callout 2), releasing the separation pad.

Step 4:
Slide the separation pad straight up and out of the tray.

Removing the tray 2 and 250-sheet feeder separation pad

Fuser

Step 1:
Remove the following covers:
• I/O cover
• DIMM cover
• rear cover

Step 2:
Remove two screws from the fuser cover and then lift the fuser cover away from
the printer.

Removing the fuser (above diag 1 of 2)

Step 3:
Use a small flatblade screwdriver to disengage the tab on one connector and then
unplug the connector.

Step 4:
4 Unplug two connectors

Step 5:
Remove two screws

Removing the fuser (above diag 2 of 2)

Step 6:
Pull the fuser straight out and away from the printer.

(<back)